top of page
Renault Can/K-line ECU

Renault Can/K-line ECU Tool key programming 2001-2015

Price£695.00

OBDII tool with various Renault car electronic control unit internal memory modification functions:

 

  • Read/Write EEPROM or FLASH

  • Clear Immobilizer Code

  • Read Immobilizer Status 

  • Program Cards.

 

There is no need to open control unit, de-solder memory IC or connect any wires directly to it.

 

All functions works by OBDII connector, but any supported control unit can be connected "on the bench" using Connection Manual. 

 

Clear Immobilizer Code function is fully automated - just press button and control unit will be cleared. ECU is ready to accept new immobilizer code after previously programmed code is cleared - no future programming is required.

BUY NOW CLICK HERE
Software V2.65 supports:

  • EDC15C3 (both CAN-BUS and WIRE immo systems) - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • EDC15C13  - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • SIRIUS 31H  - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • SIRIUS 32[N] (both CAN-BUS and WIRE immo systems) - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • SIRIUS 34 (both CAN-BUS and WIRE immo systems) - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • SIRIUS 35  - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • EMS3132 (both CAN-BUS and WIRE immo systems) - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • EMS3134 (both CAN-BUS and WIRE immo systems) - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code

  • SID301 - Read/Write EEPROM, Read/Write FLASH, Clear Immo Code, Clear IMPACT DETECTED, Read stored mileage

  • SIM32 - Read/Write EEPROM, Read/Write FLASH from HD64F7055, Clear Immo Code

  • SAFIR / SAFIR2 / SFR200 (35 / 55 pin connector) - Read TMS374 EEPROM, Clear Immo Code (car runs without immobilizer code)

  • IAW 6R.20 - Read/Write TMS370 EEPROM

  • IAW 6R.30 - Read TMS370 EEPROM, Clear Immo Code  (car runs without immobilizer code)

  • VALEO BII for ESPACE III - Read/Write (9)08AZ60 EEPROM, Read/Write mileage, Clear for Replacement, Read transponder data, Emergency Startup

  • VALEO IMMOBILIZER for LAGUNA I Ph2 (1998-2000) - Read transponder data, Configure, Reset to VIRGIN

  • VALEO IMMOBILIZER for LAGUNA I Ph1 / SAFRANE Ph1 (1995-1996) - Read PINCODE, Reset to VIRGIN

  • INSTRUMENT CLUSTER for ESPACE III (1998-2002) - Reset odometer, Erase RF remote programming  by instrument cluster connector

  • SIEMENS IMMOBILIZER for ESPACE III Ph1 (1996-1998) - Read/Write 68HC05B16 EEPROM, read transponder data

  • SIEMENS UCH for MEGANE/SCENIC ('98-'02) - Read/Write 705B32 EEPROM, Read/Write configuration, Learn Keys

  • LAGUNA II, ESPACE IV, VELSATIS, LAGUNA II Ph2, ESPACE IV Ph2, VELSATIS Ph2 - KeyCard Programming, Change VIN. Reset UCH to VIRGIN 

  • MEGANE II, SCENIC II, MEGANE II Ph2, SCENIC II Ph2 - KeyCard Programming, Change VIN, Reset UCH to VIRGIN

  • INSTRUMENT CLUSTER for SCENIC II ('04-'08) - Wake-Up by CAN-BUS for repair or to check mileage, Change language and units, Change VIN, KM, Read/Write EEPROM

  • CLIO II Ph2-5, KANGOO, TRAFIC, MASTER, VIVARO, MOVANO (-'07) - Read/Write EEPROM 93C66, Key Learning, Change VIN, Reset UCH to VIRGIN 

  • KANGOO I, TRAFIC, MASTER, VIVARO, MOVANO ('07-) - Key Learning, Change VIN, Reset UCH to VIRGIN

  • KANGOO II (2007-2012) - Key Programming, Change VIN, Reset BCM to VIRGIN 

  • MODUS / CLIO III ELECTRIC POWER ASSISTED STEERING (TRW DAE/PAS) - Clear Immo Code, Change VIN by OBDII, erase DF002 from 24C16 dump, repair CRC

  • MEGANE/SCENIC III ELECTRIC POWER ASSISTED STEERING (NSK DAE/PAS) - Clear Immo Code, Change VIN by OBDII

  • TWINGO III ELECTRIC POWER ASSISTED STEERING (JTEKT DAE/PAS) - Clear Immo Code, Change VIN by OBDII 

  • LAGUNA III (2007-2015) - KeyCard Programming, Change VIN, Reset BCM to VIRGIN

  • LAGUNA III / LATITUDE (2007-2015) - Learn ECM / ESCL in protected mode (NEW !)

  • LATITUDE (2010+) - KeyCard Programming, Change VIN, Reset BCM to VIRGIN

  • CLIO III / MODUS - Key Programming, Change VIN, Learn ECM in protected mode, Reset BCM to VIRGIN 

  • CLIO III - Card Programming, Change VIN, Reset UCH to VIRGIN

  • MASTER III (2010-) - Key Programming, Change VIN, Reset BCM to VIRGIN 

  • WIND (2010-2013) - Key Programming, Change VIN, Learn ECM

  • TWINGO II (2007-2013) - Key Programming, Change VIN, Learn ECM

  • TWINGO (2001-2006), LOGAN (2004-2008), SANDERO I, THALIA, SYMBOL - Key Programming, Change VIN

  • LOGAN, SANDERO, THALIA, SYMBOL (2008-2012), Duster (2010-2012) - Key Programming, Change VIN

  • MEGANE III / SCENIC III (2009-2015) - Card Programming, Change VIN, Reset BCM to VIRGIN

  • MEGANE III / SCENIC III / FLUENCE (2009-2015) - Learn ECM / ESCL in protected mode (IMPROVED !) 

  • KOLEOS (2008+) - KeyCard Programming, Change VIN, Reset BCM to VIRGIN

  • EDC17 / MED17 TRICORE EEPROM DUMP CRC - Reset EEPROM dump to VIRGIN, repair block checksums

  • MEGANE III / SCENIC III / FLUENCE / LATITUDE AIRBAG (CONTINENTAL) - Erase CRASH DATA by OBDII / direct connection

  • LAGUNA III AIRBAG (AUTOLIV RC5) - Erase CRASH DATA by OBDII / direct connection

  • TWINGO II (X44) / KANGOO II (X61) AIRBAG (CONTINENTAL) - Erase CRASH DATA by OBDII / direct connection

  • MASTER III / MOVANO-B / CLIO III Ph2 / MODUS Ph2 AIRBAG (AUTOLIV) - Erase CRASH DATA by OBDII / direct connection

  • AIRBAG MODULE WITH SPC560 MCU (CONTINENTAL) - Erase CRASH DATA by OBDII / direct connection

  • MEGANE II / SCENIC II AIRBAG (AUTOLIV ACU4) - Erase CRASH DATA by OBDII / direct connection

  • CLIO II X65 AIRBAG (BOSCH AB8) - Erase CRASH DATA, Read/Write MCU internal EEPROM by OBDII / direct connection

  • ESPACE III AIRBAG (SIEMENS) - Erase CRASH DATA, Read/Write MCU internal EEPROM by OBDII / direct connection

  • LOGAN X90 / DUSTER H79 AIRBAG (TEMIC-CONTINENTAL) - Erase CRASH DATA, Read EEPROM by OBDII / direct connection

  • KADJAR / TALISMAN AIRBAG (AUTOLIV AC7 with MCU XC2336) - Erase CRASH DATA by OBDII / direct connection (NEW !)

bottom of page